Product details:

Steering Cable SSC135Teleflex dual rack and pinion steering cables are specifically engineered for high-performance boaters wanting No Feedback technology. Teleflex has combined its patented No Feed - Back technology with the incredible precision and control of a dual cable rack and pinion system. This replacement Teleflex dual rack and pinion steering cable generally installs with no dash alteration and will provide years of performance for boats equipped with a non-power assisted outboard. - Twin rack cables fit SH5210p, SH5230P, SH91610P, and SH91630P helms. - How to Measure Steering Cables "Measure Twice. Order Once." Replacement of Existing Cable If possible, find the part number stamped on the plastic jacket of the old cable. If you removed the old cable, measure for the replacement cable as follows For Rack Steering Cable Replacement, Measure Existing Cable as follows Measure plastic cable jacket ("Y" dimension shown in above drawing) in inches, add 30′′, and round up to next foot. Order that length cable. - New Installation Measure cable routing path from wheel center line to engine connection, as follows A = Center line of wheel to gunwale (or deck, if routed downward), B = Dash to transom, C = Gunwale to centerline of cable connection at centered tiller. - For Cable Installations through the Engine Tilt Tube Add A, B & C + 6′′, then round up to the next foot. Order that length cable. - For Cables Mounted to Transom, Splashwell or Stringer Add A, B & C, then subtract 6′′ and round up to the next foot. Order that length cable. - TYPICAL SINGLE STATION ROUTINGA single-cable, starboard drive push-pull mechanical cable system is shown in this diagram. - Cable routings (such as those found on pontoon boats) may vary from this drawing. Confirm length by laying a garden hose or similar object) along cable path and measure run from wheel to engine connection point.